ENGINEERED FOR YOUR CLIMATE  ·  BUILT FOR WHAT’S NEXT

Tomato Nutrition: Calcium and Potassium Management

Calcium and potassium are the two nutrients that most often limit tomato yield and fruit quality, yet they interact in ways that surprise new growers. Calcium builds cell walls and prevents blossom end rot; potassium drives fruit colour, sugar, and water uptake. Too much potassium blocks calcium uptake; too much calcium locks out magnesium. A balanced feed at EC 3.5 to 4.0 mS per cm, pH 5.5 to 5.8, and weekly root-zone analysis keeps both nutrients working together rather than against each other.

Calcium: Uptake and Targets

Calcium moves in the xylem with transpiration and is delivered almost entirely to leaves. Fruit receives less than 5 percent of leaf calcium, which is why blossom end rot appears even when the feed is correct. Target feed calcium at 160 mg per litre, root-zone calcium at 140 to 160 mg per litre.

Root-zone temperature must stay above 18 degrees Celsius. Roots at 15 degrees Celsius take up calcium at half the rate of roots at 20. Heating pipes beneath the slab pay back in the first truss. Foliar calcium at 0.4 percent calcium chloride on developing trusses gives a 30 to 50 percent reduction in BER as a short-term band-aid.

Potassium: Demand Curve

Tomato potassium demand rises from 100 mg per litre in early growth to 220 to 250 mg per litre during fruit swell. A flat feed over-fertilises early and under-fertilises late. Use a two-tank system: tank A for vegetative growth, tank B for reproductive growth, and blend by truss number.

Excess potassium competes with calcium and magnesium at the root membrane. If potassium runs above 280 mg per litre, calcium uptake drops by 20 percent even when calcium in the feed is correct. Track the K to Ca ratio; a target of 1.5 to 1.8 keeps both moving.

pH and EC Balance

Root-zone pH of 5.5 to 5.8 keeps calcium, phosphorus, and micronutrients available. Above pH 6.2, iron and manganese lock out; below pH 5.0, manganese and aluminium become toxic. Adjust with nitric acid or potassium hydroxide in the mixing tank.

EC rises 0.3 to 0.5 mS per cm in coco coir due to cation exchange. Set feed EC 0.2 lower in coco than in rockwool. During dark weeks, drop EC by 0.3 mS to avoid salt build-up; during bright weeks, raise by 0.3 to push fruit sugar.

Weekly Root-Zone Analysis

Take a drain sample once per week from three random slabs. Measure EC, pH, and send to a lab for nitrate, ammonium, calcium, potassium, magnesium, and sulphate. Compare to the feed values; a 20 percent drift in any element signals a mixing or injection problem.

Track calcium to ammonium ratio. Ammonium above 10 percent of total nitrogen promotes lush vegetative growth that pulls water away from fruit. Switch to nitrate-based calcium nitrate at 1.2 mmol per litre if BER appears.

Deficiency Symptoms and Fixes

Calcium deficiency shows as blossom end rot on fruit and hooked, necrotic leaf tips. Potassium deficiency shows as marginal scorch on older leaves and poor fruit colour. Magnesium deficiency shows as interveinal yellowing on older leaves.

Fixes are short-term: a 0.4 percent calcium foliar spray for BER, a 0.5 percent potassium sulphate spray for marginal scorch, and a 0.3 percent magnesium sulphate spray for interveinal yellowing. Long-term fixes are in the mixing tank, not on the leaf.

Calcium and potassium are partners, not competitors. Hold calcium at 160 mg per litre, potassium at 220 mg per litre during fruit swell, pH at 5.5 to 5.8, and run weekly drain analysis. The 10 to 15 percent yield gain and the drop in blossom end rot pay for the lab contract within one season. Track the K to Ca ratio weekly; a drift above 2.0 signals that the mixing tank needs re-calibration before the next truss.

Next article →