ENGINEERED FOR YOUR CLIMATE  ·  BUILT FOR WHAT’S NEXT

Microclimate Zoning and Sensor Placement in Greenhouses

The Greenhouse Is Not One Climate

A large greenhouse contains several climates. Air near the inlet is cooler and drier, the centre is warmer, and the zone beside a south-facing wall receives more radiation. Treating the house as a single environment produces advice that fits nowhere.

Zoning acknowledges these differences and manages them deliberately. The number of zones should follow structure and equipment layout: ventilation sections, irrigation valves, and heating circuits usually define the natural divisions.

greenhouse
Figure 1: Modern greenhouse by Shouguang Zhongtian

Where Instruments Belong

Climate sensors should sit at canopy height in a shelter that blocks direct radiation and allows air to pass. In practice, aspiration or a correctly sized radiation shield distinguishes a useful reading from a misleading one.

One sensor per zone is the minimum, and the sensors should be compared continuously. A zone that consistently reads two degrees higher than its neighbours is either genuinely warmer or has a faulty probe; the shape of the difference over the day tells you which.

Vertical Gradients and Root Zone

Temperature and humidity stratify vertically, especially under screens and above dense canopies. Sensors at two heights reveal that gradient, which matters because the crop occupies the lower layer while the controller often samples the upper one.

Root zone sensing is a separate discipline. Substrate moisture and electrical conductivity probes, positioned in representative slabs rather than in the easiest ones, show what the plant actually experiences, which can differ sharply from what the inlet solution promises.

greenhouse
Figure 2: Professional growing system

Managing Zones Independently

Independent ventilation sections allow a warm zone to be vented without cooling a cooler one. Where structure does not permit this, the strategy shifts to mixing air thoroughly so that the difference stays small.

Irrigation zoning is usually simpler and more valuable. Splitting the house into valves sized to pressure capacity, and grouping plants with similar light exposure, improves uniformity more than adjusting the mixing tank ever will.

Records and Learning

Zoned records turn observation into management. Plotting yield and quality by zone against climate by zone reveals which microclimate produces the best fruit, and that finding is specific to that site.

Most operations discover that one zone consistently underperforms, and that the cause is a structural detail: a cold wall, a leaky door, or a shading element. Without zoned records, that pattern remains invisible for years.

Communication between climate control and irrigation zoning prevents contradictions. A zone whose vents open earlier dries faster and needs more water, and a control system that shares that information across functions avoids the situation where climate management and irrigation management fight each other.

Comparing zones is a diagnostic habit worth building. Where two zones with identical settings and identical crops diverge, the difference is structural: a leak, a fan, a shading element, or a sensor fault. That comparison is the fastest way to find faults that would otherwise persist for seasons.

Zone boundaries should follow the physics, not the drawing. A zone that spans a heated end wall and a cold door will always show internal variation, and no amount of sensor averaging will make its control accurate.

Retrofitting zones into an existing structure is usually feasible and usually worthwhile. Additional sensors and separate damper or valve control cost a modest fraction of a new build, and they convert a uniform control strategy that suits no part of the house into one that suits most of it.

Vertical gradients matter as much as horizontal ones. Temperature and humidity within a tall crop canopy differ substantially between the floor and the head of the plants, and sensors fixed at a single height describe only one layer of a genuinely stratified environment.

Conclusion

Managing a greenhouse means managing several climates at once. Zone deliberately, instrument honestly, and read the differences. Shouguang Zhongtian designs greenhouse control systems with independent zones, canopy-level sensing and root zone monitoring matched to the structure.

Next article →