Gray mold (Botrytis cinerea) and powdery mildew (Podosphaera aphanis) are the two most damaging diseases of greenhouse strawberry, together causing 15 to 30 percent fruit loss in a poorly managed season. Gray mold rots ripe fruit and browns flowers under cool, wet conditions; powdery mildew covers leaf undersides and fruit calyxes with white growth and reduces sugar content. Both diseases thrive in the 15 to 25 degree, 70 to 90 percent humidity band that strawberry prefers, so control must be built on climate, resistant cultivars, and a timed spray program rather than on rescue chemistry.
Disease Cycles and Symptoms
Gray mold infects flowers first; the fungus grows down the pedicel and into the developing green fruit, then erupts as brown rot on ripe berries. Tiny brown lesions on petals are the early warning. The disease spreads by spores in air currents and by contact between infected and healthy fruit. Cool 15 to 20 degree nights plus leaf wetness above 6 hours trigger epidemics.
Powdery mildew starts as pale purple spotting on leaf undersides, then develops a white fuzzy growth. Infected leaves curl upward and become brittle; fruit is dull and seedy, with a grayish calyx. The disease spreads fastest at 20 to 22 degrees and 80 to 90 percent RH without free water. Unlike most fungi, powdery mildew does not need rain; high humidity alone is enough.
Climate and Canopy Management
Hold daytime air at 18 to 22 degrees and night at 12 to 15 degrees. Relative humidity must stay below 75 percent; vent for 15 minutes after sunrise to purge condensation, and run horizontal fans at 0.4 m/s between rows. Avoid late-afternoon irrigation; wet foliage at night invites botrytis. On elevated bags, space rows 1.2 meters apart and remove older leaves at each harvest to open the canopy.
Remove dead petals and sepals from fruit after pollination; botrytis overwinters in these debris. At each harvest, cull infected fruit and place it in a sealed bag for off-site disposal; do not drop it on the floor. Prune runners and yellow leaves to keep air moving. A clean, open canopy reduces disease pressure by 40 to 50 percent compared with an unpruned one.
Resistant Cultivars and Clean Stock
Choose cultivars with good disease resistance. ‘Albion’ has moderate powdery mildew resistance but is susceptible to botrytis in wet seasons. ‘San Andreas’ is moderately resistant to powdery mildew. ‘Camarosa’ is highly susceptible to both; avoid it in high-pressure years. Check variety trial data for your local disease pressure; resistant lines reduce weekly spray costs by 30 to 50 percent.
Use certified virus-tested runner plants. Virus-infected plants are weak and more susceptible to both diseases. Do not bring in plants from unknown sources; quarantine new introductions for 14 days. Disinfect benches and bags with 0.5 percent peracetic acid between crops. Remove all crop debris within 24 hours of final harvest.
Protectant Spray Program
Begin preventive sprays at first bloom. For botrytis, alternate fludioxonil at 0.5 mL/L and pyrimethanil at 1 mL/L every 7 to 10 days during flowering. For powdery mildew, apply sulfur at 2 g/L weekly as a protectant, alternating with myclobutanil at 0.3 mL/L. Do not apply sulfur when temperatures exceed 25 degrees; it can burn flowers and harm bumblebees.
Time sprays in the evening when bumblebees are back in the hive. Rotate products by FRAC group to avoid resistance; never use the same active ingredient more than twice in a season. Stop all bee-toxic sprays 48 hours before hive introduction. Track spray dates in a logbook; scouting twice weekly catches new infections before they spread.
Biological and Rescue Options
Biological control options include Bacillus amyloliquefaciens at 10^8 CFU/mL as a foliar spray every 7 days for powdery mildew, and Trichoderma harzianum at 2 g/L as a drench for botrytis. These are protectant rather than eradicant; apply before symptoms appear. They are compatible with bumblebees and fit organic programs.
If infection exceeds 10 percent of fruit, pull the block early rather than spraying repeatedly. A late-season rescue spray costs more than the remaining crop is worth. Track disease incidence by block over 3 seasons; the data will tell you which blocks need preventive spraying and which can go clean. Zhongtian Agricultural Technology supplies climate stations, vent actuators, and canopy fans that hold the 60 to 75 percent RH and 0.4 m/s air movement bands automatically, which is the single most cost-effective disease control.
Gray mold and powdery mildew are climate diseases as much as they are fungal. Sub-75 percent humidity, open canopies, petal removal, resistant cultivars, and a timed FRAC-rotated spray program keep losses under 5 percent without the cost and resistance risk of repeated rescue chemistry.



