The transplant is the foundation of a cucumber crop: a well-grown 4-week-old seedling reaches first harvest 3 days earlier and yields 10 percent more than a stressed tray. Cucumber transplants are grown in rockwool plugs, coco coir blocks, or peat pots, under climate control that balances warm roots, moderate top growth, and hardening off before planting. A transplant nursery is a precision operation, not a corner to cut.
Substrate and Sowing
Sow one seed per 4 cm rockwool plug, pre-soaked in pH 5.5 nutrient solution. Alternative: coco coir block at 50 mm cube. Cover seed with 1 cm of vermiculite to retain moisture. Cucumber seed germinates in 36 to 48 hours at 28 to 30 degrees Celsius root zone; cooler temperatures slow germination and produce uneven trays.
Keep germination dark for the first 36 hours, then move to 16-hour light. Target daily light integral at 8 to 10 mol per square metre at the tray level. Supplemental LED at 150 micromoles per square metre per second for 12 hours produces a sturdy, non-leggy seedling. Leggy transplants (stem over 3 mm diameter and 8 cm tall at day 14) never recover.
Climate in the Nursery
Day temperature 24 to 26 degrees, night 20 to 21. Drop by 1 degree at day 10 to slow stretch. Relative humidity 70 to 80 percent for the first 10 days, then lower to 65 to 70 to harden. Wet leaves invite Pythium; water by sub-irrigation rather than overhead spray.
Root zone temperature must stay 22 to 24 degrees. Use a heat mat under the trays in winter; cold plugs at 16 degrees produce stunted seedlings that take 10 days to recover after planting. Air temperature can drop a degree, but root temperature must not.
Fertiliser on the Plug
Start feeding at day 5 with half-strength cucumber feed: EC 1.2 mS per cm, pH 5.5. Move to full strength at day 14: EC 1.8 to 2.0. Keep nitrate at 80 to 100 mg per litre, calcium at 100, potassium at 100. Do not over-feed; a salty plug delays root growth after transplanting.
Check plug moisture daily: the plug should feel damp, not wet. Overwatered plugs go anaerobic and trigger Pythium damping-off. Allow the plug to dry back by 10 to 15 percent between irrigations; this encourages root growth into the slab after planting.
Hardening Off and Planting
Harden the seedlings over 4 days before planting: reduce temperature by 2 degrees and RH by 10 percent. This slows top growth and strengthens the stem. At day 28, the seedling should have 3 to 4 true leaves, stem diameter 4 to 5 mm, and a white root ball visible through the plug.
Plant at the same depth as in the plug, do not bury the stem. Cucumber does not root along the buried stem like tomato, and burying causes stem rot. Water the slab with 200 ml of 22 degree nutrient solution at planting; cold water at 14 degrees shocks the roots. Expect 100 percent establishment if temperature is correct.
Disease and Pest Prevention in the Nursery
Pythium and Rhizoctonia damping-off are the main nursery diseases. Use new plugs each cycle, do not reuse trays without steam treatment at 90 degrees for 30 minutes. Apply a Trichoderma drench at day 7 at 1 g per litre to colonise the plug and suppress Pythium.
Monitor for thrips and whitefly on yellow sticky cards at 1 per 50 m2. Release Amblyseius swirskii at 100 per square metre at day 14 to prevent thrips establishment. Zhongtian Agricultural Technology treats the transplant nursery as the biosecurity front line: no visitors, no second-hand trays, and a separate tool kit for the nursery only.
A cucumber transplant is a precision product: 28 days, 24 degree roots, half-strength feed, hardening off. Cutting corners on the nursery costs 3 to 5 days and 10 percent yield per block. The transplant stage is where the whole season’s yield is quietly decided.



